- This topic has 286 replies, 1 voice, and was last updated 14 years, 6 months ago by
.
-
Posts
-
2 EDS
the configuration is relatively simple.
send me an e-mail to gh@sicres.md and i’ll help you with configuration.EDS,
it is not very difficult to config. i have some experience in it. if you want i can help you set it up. email: kashifned@yahoo.com
ED,
First you must understand the gateway command, then you draw out the requirement of you need. With the table requirement you draw should be no problem.
I was implemented to my multinational company. Or you give me the specification and requirement I help you to confgure it.
Have anyone facing ports blocking issue. Especially the RADIUS, H323 and TFTP for voice prompt.
EDS
go and check this address http://www.techland.co.uk/shared/techdocs/cli419.pdf you will find all you need.
send me and email to Abmoalin@Yahoo.com we will share our knowlodgy
hopefully thing will ok for you
Hi,
I m planning to buy quintom softswitch can any body suggest which is best for us and where can i get the brocture for quintom softswitchJohn
Vasil
Hello
Can you tell me how I make quintum 800 redirected IP’s(Behined a Proxy) availeble on the netHi, All;
I have a Quintum D-2400 and a T1 GSM Channel Bank. Now, i want to do call origination for pre-paid calling card for this i have IVR, Radius, billing software installed in a server. can anybody sent the Quintum D-2400 configuration for this perpose.
Hi i am using Qintum A800 and AS 400 i am facing Echo problem. Is there someone here to help me to figure it out that which configuration we do to solve that echo.
Make sure that you have set your echo cancellation parameters on your 5400:
For example:
voice-port 1/1:D
input gain 2
echo-cancel coverage 32 (This is the ECHO CANCEL parameter I was talking about)
cptone GB
timeouts initial 120
timeouts interdigit 2
timeouts call-disconnect infinity
timeouts ringing 60
description TRUNK#1
bearer-cap SpeechNeed help my quintum is on a booting loop. Keeps reloading at this point
Scanning for zip file…………….
Found file at 0x2830020am unable to key in any commands at console
2 Noname
I cannot access my A800 neither through Console or telnet, after i changed the IP, Through consol i get a resetting loop
Scanning for zip file…………….
Found file at 0x2830020I cannot get to Modify(M) or continue (C),
I cannot access my A800 neither through Console or telnet, after i changed the IP, Through consol i get a resetting loop
Scanning for zip file…………….
Found file at 0x2830020I cannot get to Modify(M) or continue (C),
Please help me to get into my A800, i cannot get in via telnet or console.
How can i configure the quintom to call from one pbx port to enather on same quintum?
How can i configure the quintom to call from one pbx port to enather on same quintum?
