[Ahuramazda59]

hi , how can I block my caller ID in other phone when I call them ?

[Tassos,]

I have a serious problem
I want to configure a cisco 1760 fxs-fxo with panasonic pbx 500, like this:

Analog phone-router cisco- PPP – router cisco- Panasonic pbx.

The problem is when i call from pbx -the number of the phone port- i listen a tone and only after i can take the number of the Phone on fxs.How i can configure to call from pbx directly to analog phone on fxs.

[Saul Bejarano]

Tassos:
Your problem is not answer supervision but cisco configuration, you have to configure the right dial-plan on your cisco gateway, basically set up the dial-peers correctly.

[Elie]

is the answer supervion problem also available in the new analogue and DX Digital when we enable the ProgTone?? as it was available in A800??

Elie

[Tassos]

thanks,
but the big new problem are in the disconect times or in the way that cisco “understand” the td-500 panasonic when the user from pbx put the phone down.So, When a user from pbx/fxo call the remote user at fxs,the remote user rings correctly.BUT if this user don’t pick-up and the local(fxo) close the phone the line-ringing remains -up.If anyone knows anything about Cisco vs Panasonic,please talk…
thanks….

[Tassos]

Happy New Year guys.

[Saul]

I can take a look at your cisco configuration, please send me your show run.
saul@procomm100.com

[Tassos]

Goodmorning from Greece.
After 11 hours of hard test i found the finaly synthesis of timers(cptone\freq/caedence/dbm0/….).
I’m really thanks the people who looks for me.
StBy.

[Shashank]

hi

Anyone can help to know how can i use CAC 24 T1 Channel Bank with CDMA or GSM ( FCT )

Its an urgnet

regards
shashank

[Saul]

For CDMA you can use cell sockets, for GSM you can use a GSM channel bank like Valiant, Orion or some other european GSM channel bank, in case you want to use cell sockets please do not post your bad experience back 🙂 they work but is really not painless, it will hurt your asr when you have a cell socket not working.

[VOIP Brett]

I am configuring a cisco as5350 with an t1 carrier access cb.

Configuration:
mode cas
framing sf
clock source internal
linecode ami
ds0-group 0 timeslots 1-24 type fxo-loop-start

Can someone tell me switch settings on the CAC Channelbank?

[raul]

Hi I´m from Guatemala and i have a Clarent Gateway 1200. I don´t have any information about the configuration of the software could any of you help me with some information or manual. Thanks.

[Nobel]

I need to block ID sending using cisco AS5300 or Quantum A800, I want to know i there is any configuration or software that could block the number from appearing on mobiles or landlines with caller ID devices, can anyone advise pls..Thanks..

[To Raul about Clarent]

There is no information that is available online about Clarent.

The Clarent units do not work by themselves, only under the control of a master unit, called the comand center.
If you only have a gateway, all what you have is a old PC with some DSP units and FXS or T1 interface.
I have myself some gateways 100, a command center and a gatekeeper, all of them unused because you need to buy the licence to operate them.

Good luck

[Nobel]

Would the cisco AS5300 operate with a CAC CB or would there be answer supervesion issues? Thanks for your swift and kind advise.

[Author]

Posts