16th May 2002 at 00:42
#21587
MB
Guest
Hi Aushman
Sorry for not writhing earlier. A problem was actually sorted.
We only had 6 lines connected; under cross-connect section (p32mxi) we had all 30 signalling channels configured.
Cisco was getting the signal on lets say channel 10. Not having FXO on that channel p32mxi could not start the call.
When I changed the number of signalling channels (under cross connect) to total number of 6 equal to number FXO cards, changed cisco’s to time slot 1-6. All started to work fine.
By the way, I changed signalling to E&M Immediate too…Did not try the Wink-Start.. but I am sure it will work too…
Thanks for you reply
BM