Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

D3000 web interface not active

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #30618

    My D3000 web interface does not work. system S/W version is P4-2-20-40, and i cannot find the “disablegui” command under config sys#

    I did port scanning to the unit and found no httpd port

    Anyone know how to enable the web interface, or if i should upgrade the software?




    All generation 1 Tenors (A400/A800, D8/D16/D24/D3000) web interface was disabled via software some time ago as the web interface in gen 1 did not work well. You can only use the CLI.


    Wilson Boyrie

    For what that GUI was worth, you did not loose much. That was one of the very early attempts from Quintum to have a GUI.
    Completeley useless, used to create conflicts that needed to “flush” the system back to factory default, and re-create the whole configuration via CLI.

    Learn the CLI, it is worth the time that you spend on it.
    Even if you have one of the newer DX or AX systems.

    Best luck

    Wilson Boyrie.

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.