- This topic has 11 replies, 1 voice, and was last updated 10 years, 5 months ago by Vikas Sehrawat.
20th August 2010 at 07:36 #64071vikas sehrawatGuest
Anyone can tell me what are the reasons for decreasing the EDGE DL Throughput & how to increase the same.20th August 2010 at 10:57 #64072vikas sehrawatGuest
Hi Pix can u plz provide me something on this EDGE DL THROUGHPUT29th August 2010 at 09:45 #64073HasanGuest
Just review whether Abis resource is available there. Also the pcu resource.14th September 2010 at 09:18 #64074EDGE DL ThroughputGuest
yes there is enough resources14th September 2010 at 11:31 #64075SotonGuest
How many TS you have set for EDGE?21st September 2010 at 10:04 #64076EDGE DL ThroughputGuest
1-STATIC TS is for EDGE & 1 for GPRS & all others are dynamic TS for both .
We have maximum configuration is 3/3/321st September 2010 at 18:28 #64077TanujGuest
What is your equipment, how many sub time slots have you allocated for the corresponding Edge channels.. Please also check for Brp/dsp overload23rd September 2010 at 10:00 #64078Vikas SehrawatGuest
everthing is tunned no dsp congestion is there23rd September 2010 at 10:01 #64079Vikas SehrawatGuest
m working on SDR(ZTE SYSTEM)23rd September 2010 at 13:33 #64080TanujGuest
i am also working on zte system only. Are the channels defined on bcch or are distributed on both bcch and non bcch. Because we had the same problem of low throughput in our NW too. Also what the max no. Of time slots being given in each dsp.23rd September 2010 at 13:42 #64081TanujGuest
if the pd channels are on different carriers its of no use as the user will get only one frequency at one time. Take one site only, balance the dsp overload if any, shift all the sd channels on non bcch, leave the default channels like fach on bcch and then test the throughput i am sure you will get results. We were earlier getting only 13kB At max but now have gone to 30kB with 2 static and 2 dynamic config.29th September 2010 at 13:57 #64082Vikas SehrawatGuest
Thanx Tanuj for ur response,i have given 1 static pd channel on bcch & 1 static on non-bcch trx,and i know 1 user get 1 freq. at a time but my configuration is like 2 static & all dynamic .
Even in data drive m getting 2UL+4DL TS in gud C/I with gud coverage m not getting consitent speed, for a instance m getting more than 240kbps ….also EDGE DL blocking is more than 8% .so how to improve all these?????