Erlang greater than the no. of TCH This topic has 4 replies, 1 voice, and was last updated 13 years, 5 months ago by Vijay. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts 8th July 2010 at 10:45 #63472 Vijay Kumar BansalGuest Hi, If we refer Erlang B table with GoS of greater than 30% then the equipped traffic is greater than the number of TCH… how is it possible…?? 9th July 2010 at 12:12 #63473 pixGuest hi, the value of the traffic that you see in the erlang table is the incoming traffic. 30% of the incoming traffic is rejected, while 70% is carried by the system. Multiply the value of the traffic by 70%, I’m sure it will be less than the amount of channels. regards pix 11th July 2010 at 07:33 #63474 VijayGuest Hi Pix, Ok…the value in Erlang table is equipped erlang and equipped erlang can be less than or greater than the carried erlang…is it so?? thanks regards, vijay 11th July 2010 at 09:17 #63475 pixGuest in the erlang table, you se the “offered” traffic, which I called the “incoming” traffic. The “carried” traffic is not shown, but can be calculated = incoming traffic * blocking rate. regards pix 12th July 2010 at 17:08 #63476 VijayGuest HI Pix, Thanks a lot.. Author Posts Viewing 5 posts - 1 through 5 (of 5 total) The forum ‘Telecom Design’ is closed to new topics and replies.