- This topic has 3 replies, 1 voice, and was last updated 11 years, 4 months ago by pix.
11th December 2009 at 02:58 #60142NarchaiGuest
I’m working in alcatel’s network software B9.
now i had problem in serveral cell having high TCH assign fail radio it only happen on non BCCH trx. we already replaced TRC ANC hardware and TRE cable and also asked OMC-R to recreate cell database.
but cell KPIs still degraded
Can anyone help in this matter what should i do?
thank you in advance11th December 2009 at 19:32 #60143PixGuest
good to see you have probably troubleshoot any possible HW failure. Now is the time to investigate radio problems.
Are you using frequency hopping ?
Let’s take one cell. How many TRXs ?
Can you give the TCH alloc efficiency rate @ BH and average during the day
and the TCH Traffic Erlang @ BH and average during the day
PER TRX. (the TCH efficiency is a TRX indicator, I forgot the exact name… should be in the family “RTCH Assignment > Execution”)
If only one TRX is impacted, try to reduce the TRX PREF MARK on this TRX, and increase the TRX PREF MARK on another TRX.
If problem still here, try with another TRX and so on.
Waiting for your reply,
-pix14th December 2009 at 09:37 #60144NarchaiGuest
Thanks for you reply.
Cell that using Non_hopping and hopping configuration.
following is one case the cell having 4 trx with non_hopping trx pref_mark value trx1 = 1 for other set to 0
trx1 = 4.9
trx2 = 6.7
trx3 = 4.8
trx4 = 7.8
trx1 = 14
trx2 = 2047
trx3 = 1246
trx4 = 11
trx1 = 186
trx2 = 2799
trx3 = 1820
trx4 = 349
trx1 = 97.3
trx2 = 25.9
trx3 = 30.9
trx4 = 96.8
we already try to remap trx to other TRX but the problem still havepen on TRX2 and 3
thank you vary much for you help14th December 2009 at 14:28 #60145pixGuest
as a temporary workaround, put the trx pref mark to 7 on trx2 and trx3.
thanks for the indicators, those are exactly the ones I was asking for.
could you also give me the path balance (it is located in the TRX / Indicators / Radio Measurement / Path Balance / Path_balance_avg)
The problem is definitely a hardware problem… and that should translate as a poor path balance
do you know if those 2 TRX (2 & 3) are connected to the same side of the ANC ? (the ANC can be seen as “two sided” : the 2 top TRXs and the 2 bottom TRXs… each halves of the ANC is rather independant form the other)
also, i would recommend checking fi there is no feeder swap between the BTS and the Antennas, or perhaps even within the BTS. But in this case you should also see some problems in other sectors of this BTS. Unless the other sectors do not carry much traffic.