Edge Performance This topic has 4 replies, 1 voice, and was last updated 14 years, 1 month ago by Jacky. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts 12th January 2009 at 08:07 #55318 JackyGuest how can we perform edge throughput enhancement? 12th January 2009 at 09:22 #55319 PixGuest There are different types of limitations, but mostly 2 families: – interfaces limitation – interference limitation — interface: check that your Abis, Ater PS and Gb interface are not too loaded. If above 70%, you can expect some shrinking of the throughput. — interference: check that your average C/I in the area you want to enhance is above 20dB or even more if possible. 12th January 2009 at 09:37 #55320 JackyGuest Thanks pix, one more think, how could i monitor and enhance the C/I? 12th January 2009 at 11:37 #55321 pixGuest C/I reflects the amount of interference : high C/I –> no interference low C/I (less that 9dB) –> high interference the amount of interernece depends on the quality of your frequency planning, that’s all… 😉 12th January 2009 at 13:10 #55322 JackyGuest Thanks 🙂 Author Posts Viewing 5 posts - 1 through 5 (of 5 total) The forum ‘Telecom Design’ is closed to new topics and replies.