- This topic has 13 replies, 1 voice, and was last updated 14 years ago by
.
-
Posts
-
Hi,
Does anybody has idea about SDCCH drop reason “Suddenly Drops Coneection”. What could be the reason of Suddenly drop connection?Which vendor equipment is this?
hi all,
Pls snd me details in one bye one as SDCCH Drop, Block, TCH Drop, Block, SDCCH Congestion, TCH congestion and CSR, all reason requried in only GSM, CSSR.,,,,,,,,,, Waiting ur response all“SDCCH drop due to Suddenly drops connection” this will happen if subscriber get into lift or basement so signal will suddenly dropped –> sdcch/tch drop. please audit direction of antenna and adjust it.
HI
My network suffering form TCHDR in some cells, I want for you more information to process that and what the Parameters affection for this issue
thanks
BR
Kinghi all,
can u pls tell me abt sd,tch drop & congestion causes as well as and steps required to minimize these…..waiting 4 ur responsehi pix,
i want to know direct retry,cell load sharing parameters of nokia systemDR i.e Direct retry is a feature in Nokia System.
With DR enabled if SD is allocated & all the TCH are busy then TCH is allocated from a different cell(neighboring cell).
As far as cell loading parameters is concerned there is a very good feature in Nokia Sys i.e TRHO
(Traffic Reason Handover) with this paramter enabled u can offload ur highly congested cells bt be aware of TGT value else there will be ping-pong handoveres.PSR-Paging Success Rate,
CSSSR- Call SetUP Success Rate,
SD Drop,
TCH Drop,
SD Congestion,
TCH Congestion,
SD Block,
TCH Block,All Reasons & rectification done by rf issue.;;;
Waitting ue response early..
Main factors causing high SDCCH Drop rate are as follows:
(I) Inappropriate parameter configuration (system information)
(II) Inadequate system capacitySolutions:
(1) Parameter modification (threshold of random access error, RACH access threshold),maximum times for retransmission, the number of TS in transmission expansion.
(2) Attention to parameter configuration for partition of location area and location renewal update (configuration for 1800MHz dual band network, CRO, cell reselection hysteresis parameters, time for periodic location etc.,)
(3) In Dual band networks, an exceedingly high rate of excessive location renewal update may be caused by an exceedingly high rate of excessive handover between mobile switch offices centers. Modification shall be made to handover parameters of the 1800MHz dual network, CRO, etc
(4) Apart from factors mentioned above, there might be capacity problems. SDCCH configuration number shall be increased or dynamic SDCCH assignment function and TCH carrier shall be engaged.
Hi ,Everyone I am working on Huawei system, Can anybody what is the diff b/w TCH Drop and SD Drop $ TCH Blocking and SD Blocking.
PSR drop reason
hi all,
pls send me reason for SD drop,tch drop ,tch assignment.
can a transcoder misconfiguration cause SD drops, or does it only cause drops on TCH? thanks
- The forum ‘Telecom Design’ is closed to new topics and replies.
