hello sadiki,
NO HO COMMAND INITIATED
–> What kind of message is that ? It is not a layer 3 msg from the Air interface, so where have you seen this message ?
In your drive test tool ? In such case, this msg is generated by your DT tool itself, not by the BSS.
Your problem looks like the HO is not triggered even though the quality is bad, or that there is no “good” neighbour available.
In which cell does this problem occur ?
Cell at MSC border ?
Cell at LAC border ?
Cell “inside” a LAC ?
Cell without neighbours ?
When you see this, what is the problem ? Bad RXqual ? Low RxLev ? Better cell ? High TA ?
There are some E/// parameters that could filter out all possible candidate cells, so you should check them out (i don’t know their names…).
Regards
pix