Generic selectors
Exact matches only
Search in title
Search in content

ANIType 1 with credit timer in DX2030

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #29485 Reply
    Sujit Roy
    Guest

    Hi,

    I am using a Quintum DX 2030 for call origination and currently using IVR type 2. I want to use PINLess authentication (ANI type 2) . But the problem is after the user dialed destination number, quintum is not starting the credit timer and as a result user is not disconnecting.

    HOw can i start the credit timer in Quintum DX 2030 ? Please help me. I will be grateful.

    #29486 Reply
    MikeM
    Guest

    Sujit,

    As I recall, the credit timer should not start till the destination number answers and the DX receives the connect from the destination end.

    Mike

    #29487 Reply
    Wilson Boyrie
    Guest

    You are correct Mike

    The credit timer starts deducting minutes(or seconds) from the ammount that the billing system sent to the gateway, when there is a answer on the remote end.

    You are not getting a “start of communication” from the remote end.

    #29488 Reply
    Sujit Roy
    Guest

    Thank you very muck Mike for your response.

    But the problem is DX receives the connect from the destination end but it does not start credit timer.

    I have seen from the evlog that it just says “Send Connected Event()”. whereas it should start credit timer after connected event but it didnot.

    #29489 Reply
    MikeM
    Guest

    Sujit,

    A send connect event message may not be the same as a receive connect. You should check the even log on this.

Viewing 5 posts - 1 through 5 (of 5 total)
Reply To: Reply #29486 in ANIType 1 with credit timer in DX2030
Your information:




<a href="" title="" rel="" target=""> <blockquote cite=""> <code> <pre class=""> <em> <strong> <del datetime="" cite=""> <ins datetime="" cite=""> <ul> <ol start=""> <li> <img src="" border="" alt="" height="" width="">