Generic selectors
Exact matches only
Search in title
Search in content
Search in posts
Search in pages

Micro_ALU causes

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #68424 Reply
    VanG
    Guest

    Hi Pix,
    please to advise me about these causes:
    1.How to remove traffic from micro to neighbours macro, because this micro is high loaded.And how to improve the HO in this micro because there are a lot HO due to bad SACCH?
    2. How to change HO parameters in two macro cells for earlier HO because these are road cells and sometime there is no HO to better cell and calls are droped..I was tried to change HO_margins but nothing happend…

    Thank you in advance…

    #68425 Reply
    pix
    Guest

    vanG,

    1/ what is your macro->micro Ho strategy ? ho PBGT, ho umbrella->micro, ho preferred band ?
    you must act at 2 levels: the idle mode and the connected mode. The whole idea is to keep “static” MS in the micro, and keep “moving” MS in the macro.

    * For idle : reduce the CRO of the micro cell, and increase the penalty time and temporary offset (pt = 60s, to = 40dB)
    * For connected : avoid incoming HO from macro-> micro by increasing the averaging window of the macro-> micro HO

    the BAD SACCH ho is very useful, but very powerful. You should strongly decrease the L RXLEV MCHO to a low level, for example : -93dBm, and keep the N BAD SACCH to a standard value (4). To keep good, qos, increase the L RXLEV DL H to -89dBm (or even higher).

    2/ for road cell : set HO MARGIN (a,b) = HO MARGIN (b,a) = 0dB, and A PBGT HO = 6 SACCH.
    if those two cells are also adjacent to “city” cell, then there is a risk of ping pong ho with them, becaus ethe A PBGT HO is so short. In this case, increase the HO Margin towards the city cell :
    HO MARGIN (a, city) = 8dB (for example)
    That will limit the ping pong effect.

    Regards

    #68426 Reply
    VanG
    Guest

    Hi Pix,
    thak you for your answer..I’ll try and give you feedback..
    BR,

    >>rrb

    #68427 Reply
    VanG
    Guest

    Hi Pix,
    I can’t find “L RXLEV MCHO “. You mean U_RXLEV_DL_MCHO (now is -91dBm) or not ?

    #68428 Reply
    pix
    Guest

    vang, yes, that’s the one and only one !

    the default value is rather high (IMO), but it really depends on many many things.

    Apply my previous mail carefully, that willl give you solid grounds for wild & fun optimization 😉

Viewing 5 posts - 1 through 5 (of 5 total)
Reply To: Reply #68425 in Micro_ALU causes
Your information:




<a href="" title="" rel="" target=""> <blockquote cite=""> <code> <pre class=""> <em> <strong> <del datetime="" cite=""> <ins datetime="" cite=""> <ul> <ol start=""> <li> <img src="" border="" alt="" height="" width="">