- This topic has 9 replies, 1 voice, and was last updated 4 years, 9 months ago by AWANISH MISHRA.
18th January 2011 at 12:15 #65558NADELGuest
What make up the SABM message sent from the MS to the BTS?30th November 2011 at 07:08 #65559vikasGuest
I WANT KNOW ABOUT SABM IN TELECOM8th December 2011 at 06:15 #65560Mithu_BLGuest
After getting immediate assignment through AGCH the MS switches to the assigned channel and activates it. By sending an SABM frame containing a „Service
Request Message“, it switches the SDCCH to the „Multiple Frame Acknowledge“mode, there by activating it. The Service Request message helps the network to recognize the service being requested by the MS. This information is used to decide
how to proceed.
Service request messages are:
· CM SERVICE REQUEST
· LOCATION UPDATING REQUEST
· IMSI DETACH
· PAGING RESPONSE
· CM REESTABLISHMENT REQUEST
Than the BTS send the acknowledgement that it has receive the service by means of UA frames.11th December 2011 at 17:54 #65561vikasGuest
Thanks a lot for sharing this concept of SABM. In future how to contact you mithu??12th December 2011 at 08:04 #65562vikasGuest
What is the difference between cause value and cause No with respect to 3gpp papers. for reference in TS 24.008 v 5.1612th December 2011 at 10:55 #65563Mithu_BLGuest
Its my pleasure. U can mail me at:firstname.lastname@example.orgemail@example.com February 2013 at 19:27 #65564Karan ChopraGuest
SABM message structure contains SABM message field which contains the type of service requested .
Discuss the message structure in detail13th July 2015 at 12:13 #65565Sarvesh VermaGuest
RR SABM + MM CM SERVICE REQUEST
TCH, SAPI = 0
This is the first message that is sent after tuning to the
channel. The Mobile initiates a LAPm connection with the
BSC by sending a Set Asynchronous Balanced Mode
(SABM) message. The service request message meant
for the MSC is also sent in this message.
TCH, SAPI = 0
The BSS replies with Unnumbered Acknowledge (UA) to
complete the LAPm setup handshake
BSS Expert13th July 2015 at 12:33 #65566Wallis DudhnathGuest
SABM has it starting point with X25 and ISDN.
GSM is built on ISDN therefore you will see LAP-D (LAP-B points
to X25).SABM(E) stands for Set asynchronous balanced mode extended.
It is used to establish a Link Layer. For example with ISDN
several INFO messages are exchanged before a SABME is sent by the
TE. ISDN Network will send a with UA.30th June 2016 at 07:12 #65567AWANISH MISHRAGuest
HII, ANYONE CAN HELP ME TO GET KNOWN ABOUT THE WHOLE SIGNALLING ESTABLISHMENT BETWEEN THE MS AND NSS ACTUALLY WHICH SIGNAL IS REQUIRED WHAT TYPE OF CHANNEL IS REQUIRED FOR MOBILE ORIGINATING AND TERMINATING WHATEVER THE WHOLE PROCESS..
VERY THANK YOU..