- This topic has 6 replies, 1 voice, and was last updated 10 years, 9 months ago by bipin.
22nd June 2010 at 14:22 #63288bipin jaiswalGuest
I faced that issue on BCCH-Trx.most of the time ms send Assignment failure(Revision to old channel). In Tems log MS retries SABME frame,butTRX does not recieve it.can anyone please tell me the reason for that issue?23rd June 2010 at 05:30 #63289ManiaGuest
Are you talking about the Call Setup or the Handover phase..
Normally ROC is pegged when the destination TS cannot be successfully camped on and reverts. In Call setup if its assigned to inner zone and a feature like second assignment is there then too its pegged check the assignment / handover command for the TRX to which the call is assigned at. Its HW can be faulty / check its frequency, if SFN check MAL /MAIO if fixed frequency check the C/I plot of the frequencies to identify the problematic frequency. or disable hopping (and swap frequencies assigned to TRX) to check which frequency / HW is generating the Reversions24th June 2010 at 12:19 #63290bipinGuest
Thanks mania for your response. I faced that issue on BCCH-TRX in call setup scenario. Hopping is off on TRX. I had increase the bcch-tx-pwr 30dbm to 40 dbm,after that this issue was resolve. but still I do not find the reason for that issue.27th June 2010 at 19:24 #63291bipinGuest
I am still facing the same issue.
can anyone please help me to resolve that issue?27th June 2010 at 20:27 #63292pixGuest
perhaps you should describe your probleml better
is it a dualband cell (concentric) ?
which vendor is it ?
during call setup, how can a MS be reverted to the old channel ? There is no old channel !
Changing the BCCH TX POWER is weird… is there such a parameter ? Normally all TRXs are emitting at the same power, except in specific implementation of concentric cells.
pix27th June 2010 at 22:53 #63293RexGuest
Are you sure you get assignment failure (ROC) from the same cell where the call was initiated? If Yes, I’m gonna ask maybe stupid question. Is that maybe related somehow to Forced Directed Retry? SDCCH(Cell A)-TCH(Cell B) phase, TCH on Cell B is busy, go back to Cell A?! Just assumption.
Rex.28th June 2010 at 18:47 #63294bipinGuest
I am working on D-TRX(dual trx) board which is configured as bcch(TS0-bcch, TS1-sdcch/8,TS2-7-tch) and non-bcch(all tch channels)trx.
some time call is fail on non-bcch trx due to revision to old channel.if i analyze the Tems logs,in that log ms recieve the assignment command message and ms start sending sabm frame to trx. but trx did no recive it. after max. no of retry(n200), ms resume the sddch-ladm link and send assignmet failure(roc). most of the time i faced that issue on non-bcch trx. some time that scenario is happen on bcch-trx. i had doubt about frame sync between both trx.as per my understanding frame number on both trx should be same.