Free Erlang traffic calculators

The world's first online Erlang traffic calculators

Telecom Traffic Online
  Home | Free calculators | Products | Tech. papers | Forum | About us
A-Z termination - click here
A-Z termination - CLICK HERE
VoIP bandwidth calculator
  • VoIP softswitch

    DUAL Softswitch is a complete Voice over IP switching and billing solution.  Flat monthly rate.

    Web control panels; Least Cost Routing; Excel tariff uploads; SIP and H323 support.

    H323 SIP softswitch >>

  • VoIP calling

    Premium quality termination for wholesale carriers with their own VoIP switch.

    44Direct >>


    Our lowest rates for wholesale carriers with their own VoIP switch.

    44Mobile >>


    Our unique online callshop billing system.

    Bill My Calls >>

7743 MEAN HOLDING TIME BELOW DEFINED

Beau Soleil - 4th October 2017  (07:24 GMT)

I have the Same Problem. thank u Bruno for your help. but i would like to know what you mean by CU? do you want to say BCSU?

Md khalid - 14th January 2014  (20:30 GMT)

I am a BSS engineer please I want to know that how to rectify the main holding alarm 7743...please give some suggestions

ravi singh - 25th December 2013  (04:09 GMT)

Please advice how to rectiy 7743 alarm from nokia bsc...
1.7743 MEAN HOLDING TIME BELOW DEFINED THRESHOLD
00 00 00 00 01 01 00 00 02 01 2d

thanks....

bruno - 8th August 2013  (17:13 GMT)

I have been monitoring the effect of this alarm in some cells.
In one cell, CSSR and CDR was very bad but we couldn't find any radio related issue. During drivetest it was found that some 2 of the 4 trx are transmitting with very bad rx_qual and low c/i, but with good rx_lev (similar to interference, but to problem freq was found). After changing both CU everything became normal. In this particular case, alarm 7743 was being shown for 4-12 hours.
In some other case this alarm causes no severe degradation in KPI.

TRE CREATION FIU NOKIA - 20th November 2012  (11:07 GMT)

DEAR ALL ,


PLEASE HELP ME TO CLOSE THE TRE IN NOKIA SYSTEM
ALAWAYS I AM FACING THE LOOP PROBLEM & UNWANTED TRE AT BCSF NUMBER.
PLEASE HELP

narendra - 5th December 2008  (09:40 GMT)

hi,

please, can somebody helpme how to clear mean holding time below tresh hold alarm in nokia bsc,pl help me

sunggus - 6th October 2006  (09:12 GMT)

Hi, Naveen.

Nice to read your comment. But do you have a document regarding the explanation? Maybe can help me to explain what is the alarm meaning.
The 7745 and 7743 rally made me confuse.

naveen - 26th December 2005  (08:10 GMT)

i was told by one of the nokia trainers that if u have halfrate enabled in the cells then the chances of getting this alarm is high, thats because during the peak hours the halfrate transcoders could be completly full and hence that half rate call can be dropped due to transcoder pool cong. So u need to work on the half rate transcoder pool and check if there is any congestion.This could be one of the reasons apart from what has been mentioned already.

Patrick - 7th December 2005  (16:20 GMT)

If the alarm come back all the time, every days, then there is a really problem.

If you have 7743+ 7745 => check your TRX, cāble, copler or antenna.

If it not hardware => Check Bcch, you have probaly same or adjacent frequence in area.

good luck.

alexander - 6th December 2005  (02:02 GMT)

thss alarm tells you that average time of busy RF timeslot is below treshold, last value in alarm shows the average time, so 4 sec. in your example, so this 7743 alarm is just a notice for you that probably something wrong with this cell because call duration is too short, may be they are dropped because of interference or transmission problem, in many times alarms 7745 occures together with 7743...
Alex
www.dx200.biz

Other messages

Other messages: [Next 10 >>]

Post a reply to this article

Name Enter your name.
Message Enter your message.
Email Optional -  If you enter your email address in this box, then you will automatically be notified if anyone replies to your message.  Your email address will only be published if you pay to post this message.
Verification
Please confirm you are human.
Press the button to post your message.
Home | Free online calculators | Products | Technical papers | Forum | Contact us | About us

Last modified: 17 May 2017

Copyright © 2017. All rights reserved.