Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

ring back

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #31771
    armani
    Guest

    hi all;

    i’ve configured a call relay 60, and i can make calls but the problem is that i don’t hear the ring back, i’m asking if there is a way to know the cause of this pb or what i can do to know it

    thanks

    #31772
    MikeM to Armani
    Guest

    Ring back is sent from trm end to org end. Does call ever connect and do you get 2way voice? If the answer is yes, then most likely your org device is not set correctly and needs to open the media path on ringing. If you do not get voice in both directions, then you need to look at the config of your CR and test direct to the end device to see if there is port blocking.

    MikeM
    mike_voip@hotmail.com

    #31773
    Jayashree Sanyal
    Guest

    Hi ,
    II am not sure about the setup that you are using . But in order for the ringback to be through , pls check whether the priginating end is receiving a response to the SETUP request , from the far end . The response to the initial setup request should put the media through for the ringback tone.

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.