Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

How to channel group on DX gateway

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #31767
    Mahbubul Hasan Chowdhury
    Guest

    Any body knows how to channel group on DX quintum. Pls reply.

    #31768
    MikeM to Mahubul
    Guest

    If you mean to add or remove channels from group, you would use the MAP command. It is described in the CLI Reference guide on how to use.

    If you are looking to separate channels from the same E1 (or T1) to 2 different groups, there is a restriction in that you are not allowed to do this if the line is E1 and/or it is a T1 ISDN/PRI.

    MikeM
    mike_voip@hotmail.com

    #31769
    Mahbubul Hasan Chowdhury
    Guest

    I want to use my dx as follows

    channel ChanGrp-SL9DV1DI1 ChanGrp-newcg
    ——- ———————- ——————
    1..20 X
    21..24 X

    where dial prefix for 1..20 is xxx
    and dial prefix for 21..24 is yyy

    pls give me detail configuration and don’t refer to quintum website.

    #31770
    MikeM to Mahbubul
    Guest

    Mahbubul,

    As I wrote above, if you have this as an E1 line or it is ISDN, you CANNOT separate channels into groups. You can only have one group.

    If this was an analog quintum you CAN separate in to different groups.

    MikeM
    mike_voip@hotmail.com

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.