Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

change ports in AXT & A800

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #31488
    Muralikrishna
    Guest

    How can i change ports in A800 & Axt

    #31489
    mikeM to Murali
    Guest

    you cannot change the ports in an A800.

    In AXT, you must edit the var_config file (ftp it from the unit) and set the H323port, send it back to the unit and perform a varconfig update.

    MikeM
    mike_voip@hotmail.com

    #31490
    Muralikrishna
    Guest

    is ther any possible to stop telnet in AXT ? And pictular ip`s to allow telnet

    #31491
    MikeM to Murali
    Guest

    You can stop all telnet access by setting disabling the managementaccess command.

    You cannot restrict telnet by IP.

    MikeM
    Mike_voip@hotmail.com

    #31492
    Knight to Mike
    Guest

    Hi Mike, Could you pls explain a bit detail how to manupulate H323 port in AXT? I mean how to ftp var_config file, edit h323 port and how to perform varconfig update? And is it applicable to AXTs only or can be done in DX and CMS as well?
    Thank you.

    #31493
    MikeM to Knight
    Guest

    the command works in all generation 2 units.

    if you need specific directions to do this, please email me directly.

    MikeM
    mike_voip@hotmail.com

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.