Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

AS400

  • This topic has 1 reply, 1 voice, and was last updated 18 years ago by Wilson Boyrie.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #30841
    Debin
    Guest

    I AM USING AS400, I want to allow all the ip in the network to make the call in my gateway. How i add the network block and netmask in epad.pls advice to allow the whole network block.

    #30842
    Wilson Boyrie
    Guest

    To aloow everything, do not enter anything at all.
    Leave the table blank, and absolutely anyone on the net could use the gateway.

    To allow only portions, look a the examples below.

    It is anormal mask for a router.

    Ip to allow 200.100.50.25 mask 255.255.255.255 will allow only one I.P.

    200.100.50.01 mask 255.255.255.0 will allow anyone that starts with 200.100.50.01 to 200.100.50.254

    200.100.01.01 mask 255.255.0.0. will allow anyone that start with 200.100.xxx.xxx

    200.1.1.1 mask 255.0.0.0 will allow anyone with an I.P. that start with 200.xxx.xxx.xxx

    Hope that that helps.

    On the allow table, if you use it, you also need to allow your own I.P., the I.P. of your gateway.

    Best regards.

    Wilson Boyrie.

Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.