- This topic has 6 replies, 1 voice, and was last updated 15 years, 10 months ago by MikeM to Saad.
11th January 2006 at 19:48 #30545SaadGuest
Can someone tel me how to send all calls form a tenor over one ip? I have phone boots and want all calls to go to say 220.127.116.11
how do i do that? a little example will be fine. do I use only one static route?
Thanks11th January 2006 at 21:19 #30546MikeM to SaadGuest
Yes you can make one static route to the destination IP and the dn pattern would simply be *12th January 2006 at 01:29 #30547Wilson BoyrieGuest
Or you could make one static route with several entries.
That way, when you get a new route, it will be easier to “split” and send calls to two or more destinations.
The only restriction that I know off, is that you could not have two static routes to the same I.P. address. The system gets really confused if you do that.
Unless that issue was fixed on the last software patches.
Wilson Boyrie.24th January 2006 at 18:55 #30548SaadGuest
Thanks guys, I did make one static route with the * dn pattern. But can’t send calls to some countries. I’m getting a bussy tone right after I dial. when i look my cdr its sending to that GK but not connecting. They telling me they have A-Z routes and opened all routes for me. what could be the problem?24th January 2006 at 19:47 #30549MikeM to SaadGuest
There could be many reasons why this is happening. Maybe the Gk is rejecting the call, maybe they need a prefix, etc. I would need to access your Quintum and watch a call to determine what the problem is. If you would like to use my services for this, please contact me at firstname.lastname@example.org.
Mike25th January 2006 at 09:43 #30550SaadGuest
well about the prefix, I have advanced dial plan with intercom enabled….so i can call my locan phones. I have a private numbers wich is working fine. PSNT prefix 0. Multiphat prefix 9 and IP route prefix 6. so when im dialling outside say london I’m dailing
64420* and its working fine. but some countries say finland, not. and this is what i get from the CDR
So My GK is sending over ip, but still not connecting???25th January 2006 at 14:15 #30551MikeM to SaadGuest
From the cdr record I see that there is a disconnect code of 34 (no circuit/channel available). This is usually sent from the destination end. Maybe the gateway that accepts calls for those countries was full at the time. I would suggest you work with your provider to hunt this down a little further. If necessary, I can work with you on this as well.