Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

pbxtg

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #30264
    amb
    Guest

    hi,
    everybody.first of all i thanks to mike who give me suggestion about nat.but still i am not still succed.it works in one way.today i want to know how to create more than one pbxtg in analog800 . if anybody know pls help me.

    #30265
    MikeM
    Guest

    AMB,

    Information on how to do this is presented in the Command Line Information (CLI) guide for the A800.

    If you go to config, just type pbx 2 to go the PBXTG 2 prompt and then type name xxxxxx (where xxxxxx is the name you want to give it). Once you have typed the name, the new trunk group will be enabled and you can configure it as needed.

    #30266
    amb
    Guest

    MIke,
    thanks once again specially to Mike and i really greatful to u. everytime u give me suggestion and it help me a lot.this clue help a lot do experiment.but do u help further about nat? pls help me

    #30267
    MikeM
    Guest

    Amb,

    There is a document on Quintum’s web site that fully discusses NAT and Firewall. It is located at
    http://www.quintum.com/support/xplatform/network/Tenor-Firewall-NAT.pdf

    I think you will find this usefull.

    Mike

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.