[Karin]

I have 2 cisco routers, one with a dual-fxs card, the other with a dual-fxo card.

I can successfully call from the PBX to the cisco with the fxo (main router) and then call to the fxs points.

But in the reverse order, if i try to call from the fxs router(remote router) to the fxo router, it calls, the fxo answers, i dial a pbx extension and it rings… the extension answers, and i can hear the voice (from the pbx to the fxs), but they can’t hear anything (the voice from the fxs to the pbx)

My configuration in the main router:

voice-port 0/0/0
cptone MX
!
voice-port 0/0/1
!
!
mgcp profile default
!
dial-peer cor custom
!
!
!
dial-peer voice 1 pots
destination-pattern 100
port 0/0/0
!
dial-peer voice 2 voip
incoming called-number .
destination-pattern 20.
session target ipv4:192.168.0.99
dtmf-relay h245-signal

My configuration in the remote:

call rsvp-sync
!
voice-port 1/0/0
cptone MX
!
voice-port 1/0/1
!
!
mgcp profile default
!
dial-peer cor custom
!
!
!
dial-peer voice 1 pots
destination-pattern 200
port 1/0/1
!
dial-peer voice 2 voip
incoming called-number .
destination-pattern 10.
session target ipv4:192.168.0.100

(i just can’t understand , maybe it’s a silly thing i can’t see)

Thanks in advance for any guidance.

Karin

[Elias Bechara]

Your issue is the nat do you have firewal or a router between the voip

I am facing only this issue with the nat

[Abhijit Bhowmick]

Check for following:

1. Ensure that your router does not have the no ip routing global configuration command.

2. Issue the voice rtp send-recv in global configuration command

3. Issue debug cch323 rtp command and the debug voip rtp command to identify the root cause.

Need more help, send email at ciscovoipresource@gmail.com

[Asim]

H.323 Microsoft Netmeeting client configuration with cisco unified call manager 4.3

i have problem for this configuration microsoft netmeeting no outbond call for voip extensions and PTCL . but received all incoming calls local extensions and outside .

[Author]

Posts