- This topic has 4 replies, 1 voice, and was last updated 20 years, 8 months ago by
.
-
Posts
-
Hi
I’ll be very glad if anybody sent to me the configuraton file of Tenor A800 with is running for origination to CISCOI will be more glad if you sit on your *** and spend some time reading Cisco and Quintum manuals.
Do not imagine that this forum is created to support your lazyness.
If you have some specific problem – ask, it will be helped.
Just my personal opinion.
T.G.
I’ve configured my Tenor Like below
Static Route #1
RouteName = test
Gkmode = Destination is a Gateway (0)
CallSignalAddress = 193.111.197.150:1720
1:888* Public LDN priority(2)but the call didn’t go out from my gateway ..
I wanna originate call from Tenor to CISCOI think girls like Teodor should keep their opinions to themselves. It must be great to be so superior.
Aminul – if you put your email address on the site I’ll help you out with a config.
The route that you are trying to setup is just for the 888 ara code, with no country code.
On the Cisco, the dialpeer needs to be setup the same way, with only the 888 pointing to a PSTN port.
1)Be sure that the Quintum is online. Go config, print and look for “unit 1” “online=1”2) Take a event log: Type ev +ch
that will enable the call handler log.
ev to get to the log
ev c to clear the log and start new.3)Be sure codecs are the same on both ends.
On the log ,look for the rejection code.
Ping from the quintum the other unit. it should be able to ping to pass calls.
Best luck!!!!
- The forum ‘Voice over IP’ is closed to new topics and replies.
