Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Quintum CMS/Cisco Interop

  • This topic has 3 replies, 1 voice, and was last updated 20 years ago by Saul Bejarano.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #26617
    Mike Franklin
    Guest

    I would greatly appreciate any info regarding the setup of a Quintum CMS being used in conjunction with a Cisco Gatekeeper.

    Thanks

    #26618
    Saul Bejarano
    Guest

    go to H323 parameters on quintum:
    set :
    Primary GK Address = xxx.xxx.xxx.xx
    Primary Auto Discovery = 1
    Secondary GK Address = 0.0.0.0
    Secondary Auto Discovery = 0
    H.323 ID = gateway01.gw
    Register DN = No(0)
    Ignore Bandwidth in ACF = yes(1)
    Default H245 Tunneling = no(0)
    Round Trip Delay = 0
    One Stage Dialing = 0
    RRQ Interval = 60
    H323 Interop Flags:
    H225 GW Protocol = h323(0)
    Do BRQ = 0
    SlaveSessionId0 = 0
    AllowFastStartOnly = No(0)
    RRQv3plus= No(0)
    ProgressInd Alert= No(0)
    StartH245Flag= No(0)
    Automatic Ext IP Update= No(0)
    RTP Verification= No(0)
    When you set this parameters note that xxx.xxx.xxx.xxx is the IP address of your gatekeeper, this will authenticate the gateway to the gatekeeper and no call authorized by the gatekeeper will be permited, the idea of a gatekeeper is to serve as a single admninistration entity to all your gateways.
    To configure the Cisco I will have to charge you.

    #26619
    Teodor Georgiev
    Guest

    Saul, the setup on CMS is a bit different. He should first login as an admin to the CMS.

    Then going to config mode (config) and then to the H323 signalling group: h323sig1

    issue –> show

    the parameters generally are all the same.

    #26620
    Saul Bejarano
    Guest

    Sorry
    You are right, CMS I did not read that part.
    Just trying to help, thanks guys.

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.