Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

AG_PCH parameters in ALU

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #68211
    VanG
    Guest

    Hi all,
    please advise me what is better for AG_PREMPT_PCH?
    Is good to be ENABLE or not? And what can be set for BS_AG_BLKS? 1 or higher than 1?
    If i am activated AG_PREMPT_PCH, it shoul be active for all sites or for any cells?
    Thank you in advance

    #68212
    pix
    Guest

    Hi,

    The principle is great, the only drawback is that your CCCH load monitoring counters (from BSS) will not work anymore. So you will have to check your Paging success% with NSS counters.

    Yes, applying those settings on the whole LAC is a good bet, even though it is not mandatory.

    AG PREEMPT PCH = ENABLE
    BS AG BLKS = 1 (you can’t put it higher than one if you enabled the AG PREEMPT PCH)

    #68213
    VanG
    Guest

    Thank you Pix..
    Best regards,

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.