Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

HOF issue

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #67394
    beginner
    Guest

    Hi again,

    I have another HOF question: After disconnet,Release, Release complate and channel release HO command comes and HO failure is occured.

    This order is not normal, isnt it? Why it is happening then?

    #67395
    aye
    Guest

    Hi,

    Yes, this is definitely not possible if you only have one MS connected during the DT. The Mobile has to be in dedicated mode before HO takes place. But the channel has been released, so the MS is in idle mode at this time.

    But if you have two MS connectred during DT, you might be looking on the ALL MS tab on your layer window. Then it is possible to see such order of messages in one window. MS1 might be released but MS2 is still dedicated and received the HO command but fails.

    regards,
    aye

    #67396
    pix
    Guest

    I agree, you must be making an error somewhere.
    After the RR Channel Release, the BSC has released the TCH timeslot. No way it can send a HO CMD to the MS. From BSC point of view, nothing is going on on this timeslot.

    On the MS side, when RR Chanel Release is received, it should reply with a “RR Disconnect” n UL. In the meanwhile, the UL TCH is still available (from a MS point of view – the MS could still send stuff in UL, though nobody is listening).

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.