Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

NSN TCH Drop

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #66068
    Cool
    Guest

    Hi experts

    Can anyone plz describe the TCH drop counter for NSN.

    DCR_34_TCH Drop ratio due to radio fail.

    What are the things that i need to work with.

    #66069
    taupaji
    Guest

    This counter gives ratio of failures due to poor rf conditions to total failures. Poor rf conditions maybe due to a variety of reasons. This counter is very common in cells with coverage issues.

    #66070
    Cool
    Guest

    Hi Taupaji

    Thanks a lot for your reply.

    Yes I’ve able to know that this due to poor rf conditions.

    The thing is, so far my knowledge, radio failure mainly is radio link timeout & t200 failure.
    Issue is why radio link timeout takes place & why t200 expires ?

    In pure siemens system from spots, It’s easily understandable that how many calls are dropping due to these issues.

    But for NSN, Flexi, report comes only with TCH drop due to radio fail.
    Formula for this is as below

    sum(tch_radio_fail)
    100 * ————————–
    sum(tch_radio_fail
    + tch_rf_old_ho
    + tch_tr_fail
    + tch_tr_fail_old
    + tch_abis_fail_call
    + tch_abis_fail_old
    + tch_a_if_fail_call
    + tch_a_if_fail_old
    + tch_lapd_fail
    + tch_bts_fail
    + tch_user_act
    + tch_bcsu_reset
    + tch_netw_act
    + tch_act_fail_call)

    Problem is, RLT for AMR seems to be OK with current configuration.
    Now it seems that there might have some interference.Let’s see.

    I was just looking for that someone has worked particularly on it or not and if has worked then what are the steps taken.

    Hope you got my issue.
    Again thanks for reply.

    #66071
    taupaji
    Guest

    Use ND217 for cause outs and refer to DX causes document to nail down phase during which call dropped and causes.
    Check drop causes during phase 15(conversation). 🙂
    For interference check whether HO_CAUSE_INTERFERENCE increases & itf_1 is outside of band1 during drop hours/days.

    #66072
    taupaji
    Guest

    btw I’m not sure about this but – T200 expiry can be due to issues between MS->BTS(MS-LOST) & BTS->BSC(TRANSMISSION/CLOCK).

    #66073
    Vikram
    Guest

    In NSN is there any counter for call drop which will give call drops due to low signal level, call drops due to ULQ, Call drop due to DLQ, Call drop due to TA. In ericsson these counters are available would like to know if the similar counters are available in NSN

    #66074
    Saifadin
    Guest

    In NSN:
    After i sent the T200S=1200ms, i got: Radio failure changed from 12% to 0%
    BUT i got, Abis failures changed from 1.5% to 12% !!!!!

    Any explanation for that?

    #66075
    Prabhakar Singh
    Guest

    Can anyone plz describe the TCH drop counter for NSN.

Viewing 8 posts - 1 through 8 (of 8 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.