Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Missing adjacency in idle mode

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #65882
    Fitz
    Guest

    Hi,
    i face some problems with a cell that has configured adjacencies for HO and reselection in OMC-R, but when do measurement with tems, the MS reports no adjacencies for that cell in idle mode . In dedicated mode is OK.
    We are using ALU. Do you have any idea about this case? 10x!

    #65883
    Pix
    Guest

    Hi Fitz,

    Have you tried to reset the SUM, and if still not enough, the BTS ?

    In your traces, can’t you see any system information message “SI5” when in idle mode ? Those messages are listing all the “reselection” neighbours.
    If these messages are
    1/ empty
    or
    2/ not broadcasted
    then the SUM is probably faulty.
    If the messages contain coherent data (BCCH of neighbours), then it is your MS that is faulty.

    Can you see some neighbours, or none at all, in idle mode ? Is it related the the freq band of the neighbours ?

    regards
    pix

Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.