- This topic has 6 replies, 1 voice, and was last updated 3 years ago by Egaru.
11th July 2010 at 15:37 #63485ponchoGuest
Is it possible to have an in-building walk-test with TEMS investigation without GPS connected and yet be able to have the RXLEV foot-print showing in TEMS during the analysis? If yes, how?
Y.11th July 2010 at 20:16 #63486ahmedGuest
yes you can ; just load the floor plan bitmap as a layer and click the pin layer and mark on the map as long as you walk …it will appear as a black dots, keep click continuously to get more samples as much as you can…then save the log and go to the mapinfo to analyze the data…….you need touch screen tablet PC.12th July 2010 at 09:08 #63487ponchoGuest
Thanks for your reply. Does it mean you can’t get it done with a normal laptop without a touchscreen?
Thanks.12th July 2010 at 09:49 #63488SHELDONGuest
You don’t need a touchscreen. Once you’ve loaded your floor plan, locate your position and start pin-pointing(using whatever pointing device ur laptop uses, be it mouse or touchpad).
SHELDON12th July 2010 at 18:26 #63489ahmedGuest
without tablet pc or touch screen it will be so hard to do the job as i used to do this job before as it is impossible to carry laptop and tems kit and walk and click on tems, even with tablet touch pc it is hard :)….go for a handy or pocket kit12th July 2010 at 20:04 #63490SHELDONGuest
I think it’s a question of the kind of TEMS kit you have. For the walk test, you need to connect only the phone and dongle, which I believe can be reasonably managed. You can even ask someone to help you out if you can’t manage alone. I don’t see the necessity of buying a handy kit (for hundreds of dollars maybe) when you can manage with a little bit of difficulty.
SHELDON4th April 2018 at 09:11 #63491EgaruGuest
Please is it possible have continuous pin points so i dont need to keep clicking to make samples, can walk then pin point a few samples and the KPIs are uniformly distributed