Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Huawei MSc in Pool

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 4th February 2010 at 17:03 #60979
    Tzupchuzhi
    Guest

    Dear All,
    Thanks for all the invaluable knowledge share.

    I’d appreciate a bit of help. We’re implementing Huawei MSc Pool in our network, and i’m hoping i could use your experience to discover hints or pointers to identified problems with Huawei MSc in pool solution.

    thanks in advance

    5th February 2010 at 11:14 #60980
    Jon
    Guest

    Tzupchuzhi, could you be more specific? i’m unclear what you want to know????

    5th February 2010 at 11:23 #60981
    Tzupchuzhi
    Guest

    Hi Jon, thanks for the reply..
    i’m looking for the following;

    1)Specific performance tuning parameters on the Huawei MGw and MSc-s for use in pool scenario

    2)Signaling gateway load balancing on Mgw

    3)Subscriber reselection behaviour.

    4)use of common SPC for all MGw and impact on BSc configuration (any proprietary protocols in use for this?)

    5)best practices for Huawei MSc pool setup and initial configuration

    6)BSc capacity factor settings for Mgw/MSS load balancing

    12th January 2012 at 21:53 #60982
    Newby
    Guest

    Dear Tzupchuzhi.

    Could you find out some hints within MS in Pool Huawei solution?

    We’ll implement the same arquitecture over here.

    Thanks

    Newby

    30th July 2012 at 11:41 #60983
    raj
    Guest

    Hi,

    Did yo guys reach any good information on Huawei pooling?
    We have 3 MSS of Huawei working in a pool. There’s been a problem with so many calls not being served by network (either we get not reachable announcement immediately after calling or with a lapse of 10-20 seconds). Paging success rate in individual MSS seems pretty good though. [btw, we tried calling a phone that was in front of us and powered on in good radio conditions)

    any ideas to share?

    28th April 2016 at 11:29 #60984
    hani
    Guest

    if I implemented MSC pool we need to GLR service to serve inbound roamers

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.