Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Effect using Switches of Differnt Vendor

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #35007
    Naveed Shaikh
    Guest

    If a telecom operator is Using
    Switches of different Vendors such as
    Seimens
    alcatel
    ericsson
    huawei
    ZTE

    Is there any Effect or draw backs of this on GOS, call failure, Signalling.
    or any other effect you know

    Regards
    Naveed
    shaikh20@hyd.paknet.com.pk

    #35008
    Prabhakar verma
    Guest

    In case the Switches are used for supporting calls viz:- ISUP based then there is no difference irrespective of the switch u use. Only incase of Tcap message would there be a difference between ansi and etsi .To solve these problem ITU standards are used.

    #35009
    Luigimex
    Guest

    You should not have problems, all the vendors designs their products following the ITU, ETSI, ANSI standards, is important to have clear idea of what kind of standar you have to use to accomplish your needs, a good example is the one sid by VERMA, other example is for example in México where per regulatory ISUP is mandatory tehrefore all the vendors has to fine their ITU standard to cover regulatory issues, finally there are many kind of switches, carriers but not problems working among them.

    #35010
    Sunil Kumar
    Guest

    Hi Naveed,

    In case of those Chineese SWITCHES-HUWEI & ZTE you may have to face some probs in the implementation stage.I dont know much abt ZTE & HUWEI,But I worked with another one Chineese vendor called as SHANGHAI BELL in Bangladesh.There they implemented a ALCATEL-S12 Kind of Switch for which they did lot of alterations in the core software as per requirements.

    Rgds

    Sunil

    suni_almnthat@yahoo.com

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.