Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Downlink Power Control

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #59211
    Baig
    Guest

    How does downlink power control function works? does the power is decreased for whole cell or its on particular TRX?

    #59212
    pix
    Guest

    it varies for each particular timeslot, depending on the rxev and rxqual of the particular call being carried.
    the power control is done per timeslot.

    #59213
    Baig
    Guest

    can downlink power control cause ping power cell reselection or handovers as for each time slot power is being varied?

    #59214
    Pix
    Guest

    No, because :

    1/ algorithms already take this into account (as long as there is PC, most of HO cannot be detected … and for the ones that can be detected, they add the power control’s current attenuation into the HO detection threshold)

    2/ the thresholds shall be tune so that PC will not be active anymore when a HO could be detected.

    For example : Low level HO will appear at -90dBm (let’s say). In this case, PC will attenuate the signal only if the RXLev is better than -80dBm.
    If RxLev is Lower than -80dBm, then PC is disabled (it means the TS is sent with maximum power).

    If you need more explanations, let me know ๐Ÿ™‚

    Pix

    #59215
    Baig
    Guest

    I’ll appreciate

    Thanx in advance ๐Ÿ™‚

    #59216
    GMN
    Guest

    Dear Pix
    could u explain about Compensation(quality and level)in simple way like u already explined ๐Ÿ™‚

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.