- This topic has 9 replies, 1 voice, and was last updated 10 years, 11 months ago by
Ds.
-
AuthorPosts
-
CF
GuestHello, I am working in an Alcatel-Lucent network and we have been facing some issues with the UL_TBF_Estab_Fail_Radio_Rate; the problem is seeing in some cells where the fails raise in one hour and then it suddenly dissappears. When we have a look at the GSM stats everything looks just fine so we are discarting RF problems. This issue is affecting the Global KPI. Gamma and Alpha parameters are set to 0.
Just FYI the KPI is around 2.6% and is needed to be below 1.5%.
Any clues?Pix
GuestHello CF,
The problem comes and goes by itself ? Do you perform any action to make it disappear ?
In ay case, I suspect that it is a little bug, hidden deep down in the software or in the database…
In other words, it can only be fixed by some action from your tac support.Regards,
PixCF
GuestHello PIX, thanks for your answer.
Yes, we have seen in some cells that the problem comes and goes by itselt while in others actions (such as BTS reset, recreation, GPU reset or HW changes) improve the performance of the sectors. Nevertheless in case that the problem is fixed by some of these actions some times comes again.
I will managed to handle the issue with the support guys.
Rgds,
CFahmad
Guesthello CF,
what is alpha & gamma ?
BR
ahmadPix
GuestAlpha and Gamma are parameters related to the Uplink Power Control in GPRS.
If they are set to 0, it means that the UL PC GPRS is disabled.ahmad
Guestthank’s pix
but where i can found them.
ahmad
pix
Guestin the omcr ?
Ds
GuestHi can anyone tell me how one can optimise the values for alpha-gamma.
what should be the values of these two when power control is enabled and alpha n gamma are having default values.band is 1800.
pix
Guesthello,
alpha/gamm is for GPRS uplink power control. They should be set in such a way that the PC is disabled. Indeed, it can lead to some failures if the PC is enabled.
I’m talking about GPRS UL PC. These 2 parametres won’t impact the GSM PC.
the values should be gamma = 0 and alpha = 1 (or 0 ?? I can’t remember)
-pix
Ds
Guestthanks Pix,
is alpha-gamma used for GPRS UL PC n not for EDGE PC?
n what kind of failures this cav cause. UL TBF failures for GPRS services???
how these values impact as increased from 0. as in our system default values are not 0.
they r mch higher than 0.
so can anyone explain this impact.thanks in advance
-
AuthorPosts