Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

T9103 expires

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #58178
    Zbigniew
    Guest

    Hi all,

    in our network we see a lot of SDCCH & TCH Abis Failures due to “T9103 expired”. The timer T9103 (Nokia default: 2 sec) measures the time between “Channel Activation” and “Channel Activation Acknowledge” on the Abis Interface.

    What could be the reason for this fault ? I think it is not related to a faulty Abis Interface because many cells show this behaviour.

    Maybe the problem is related to some other timers (which ?) in higher network elements ?

    Tnx in advance

    Zbigniew

    #58179
    Pix
    Guest

    in the channel activation, the BSC asks the BTS to activate a certain timeslot and associate ciphering and speech codec to it.
    do you think some BTS woul have a problem applying ciphering or speech codecs required by the BSC (i’m thinking about A5/3 or AMR)

    you can investigate further in this direction:
    – what is the content of channel activation
    – why the BTS wouldn’t acknowledge this message ? which field would be a problem ?

    if you have Abis failures, it would impact not only this message, but it would generate call drops, sdcch drops, etc.

    #58180
    Zbigniew
    Guest

    Hi Pix,

    here is what we have found out by now.

    The appropriate (Nokia) counter (1075 “SDCCH Abis Failure Call” shows high values) is not only incremented if the timer T9103 expires. We made a trace and it shows that the “Channel Activation Ack” is sent by the BTS in question. So the problem occurs in the next step: BSC sends “Immediate Assignment” but the MS can not hear the BTS anymore and it does not answer with “SABM”. So the BTS will not send “Establish Indication” to the BSC. Therefore the SDCCH connection is released and the call setup fails.

    We think that there might be a problem in the link balance after implementing EDGE in these cells.
    Do you have any other ideas related to this topic ?

    Tnx Zbigniew

    #58181
    Pix
    Guest

    Well, it is a radio problem then, nothing special. Why did you write a wrong definition of the counter ?

    it could be due to link balance, either on the specific trx that carries the sdcch ts, but it could be on several trx’s as well (the combiner is faluty ?)

    apart from link balance, check interference and coverage problems.

    #58182
    Zbigniew
    Guest

    Hi Pix,

    the counter 1075 is triggered by several reasons (T3109 expiry, Immediate Assignment not answered etc.). So the definition is not wrong but it is not unique …

    Zbigniew

    #58183
    homa
    Guest

    cdr

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.