Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Drive Test under Roaming Condition

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #57638
    Timz
    Guest

    Hi all,
    See the following scenario:
    MS1 has Operator X simcard
    MS2 has Operator Y simcard

    Operator X is roaming into Operator Y Network. If you perform a Drive Test with both MS1&MS2 in dedicated mode with their respective simcards in them will the CALL EVENTS and any other things be the same??

    Regards,
    Timz

    #57639
    Pan
    Guest

    Dear, Timz!
    The call scenario in your case depending on direction of call (who is subscriber A and who is subscriber B) and network implementation.

    #57640
    Pix
    Guest

    Pan, what about the authentication procedure (or any other DTAP procedure?)?

    Apart from a possible difference during call setup (during sdcch phase), handovers, measurement reports, call release, all those would be the same… if direction of the calls are the same, and if MS Capabilities are identical.

    #57641
    Pan
    Guest

    Pix, I only said about MAP procedures, because TimZ didn’t explain clearly the sense of “CALL EVENTS and any other things”

    #57642
    Pix
    Guest

    The question is a bit vague, that’s true 🙂

    #57643
    Ghost
    Guest

    Hi there guys.
    I am using Ericsson TEMS investigation 9.0.1 and my question is why “The Call End” in TEMS reach 33 sec after the call has finished when I am using USSD parameters.
    Thank you for the help in advance.

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.