Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Poor Rx Quality

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #56833
    Naseer
    Guest

    I found a cell from drivetest log file,where the downlink rx quality is very poor.The call was on TCH (hopping,synthesizer).During the poor rx quality there was no interference (C/I was very good.).Rx level was very strong.
    I found also from the carrier statistics that, downlink BER was high (>2%) for all the hopping TRX of this cell.
    Is it due to any Hardware issue? If is it, then which part of hardware we need to check??
    Clutter type is Urban.Path balance stat is ok.Drop call rate is not so high (about 2% or less then 2%).But this cell has very poor downlink quality.
    Please recommend what step do I need to resolve the poor quality issue.

    #56834
    Phantom
    Guest

    As your given detail and with my experience ,the problem is posible caused of HW I ever face like this .Try to check TRXs , Combiner

    #56835
    TNS
    Guest

    Is it Alcatel equipment?
    BR

    #56836
    Naseer
    Guest

    thanks.
    Its not Alcatel.

    #56837
    kamaz
    Guest

    HI Naseer,

    Try to desactivate hoping, and monitor the KPI’s of the cell.
    After that, if you have KPI’s bye TRX, you must monitor it.
    Can you tell us the provider just to help you.

    #56838
    Rex
    Guest

    Hi Naseer,
    What is MHT (Mean Holding Time) for each TRX? What is call efficiency for each TRX? If both of these indicators are low than change TRX.
    Regards,

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.