Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

alcatel half rate

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #56530
    andy
    Guest

    Hi
    Iam new in alcatel and i have problem that the cell is congested how should i checked the paramter for Half rate is active or not and alcatel version is B9, and is there any website to show me radio parameters as doc .
    best regards

    #56531
    Rex
    Guest

    Hi andy,
    In order to activate HalfRate for a cell, the parameter HR_ENABLED should be enabled in a cell level (somewhere in “edit cell” tabs, use “find” to find the parameter) and in abis level how many TRXs you want in dual rate (find the BTS and declare how many TRXs in DR for corresponding cell). I’m not at work to check and give you exact answer, for the moment I hope it helps.

    #56532
    andy
    Guest

    Thanks Rex and how to set the threshold between FR and HR

    #56533
    Rex
    Guest

    Hi andy,
    I’m not so sure, but I think you have to tune parameters THR_FR_LOAD_L_xx and THR_FR_LOAD_U_xx (where xx=SV1 or SV3). For example for the cell with 4 TRXs THR_FR_LOAD_L_SV1=40 and THR_FR_LOAD_U_SV1=70 (it depends, check help for those parameters).
    Regards,
    Rex

    #56534
    andy
    Guest

    thanks

    #56535
    Pix
    Guest

    Rex, that’s it, perfect 🙂
    SV1 is for *legacy* HR, SV3 for AMR HR.

    #56536
    MLW
    Guest

    CAN a DS3 do 45 Meg UP and 45 Down at the same time.

Viewing 7 posts - 1 through 7 (of 7 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.