Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Nokia alarm 2924

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #56323
    Nithish
    Guest

    Hi,

    I’ve 2924,2092&2915 alarms at a time when site fluctuation. I’ve changed the entire transmission path and ET. But problem exists..

    Pls help me

    #56324
    patrick.fr
    Guest

    2924 REMOTE END CRC BIT ERROR RATIO OVER LIMIT
    2915 FAULT RATE MONITORING
    2992 BTS AND TC UNSYNCHRONIZATION CLEAR CALLS ON A INTERFACE

    It’s a quality of PCM problem.

    What have you with command:
    ZYMO:ET,xx;

    In normal functionnement
    SLIPS:
    POSITIVE = 0
    NEGATIVE = 0
    LOCAL ENDS = 100 EFS
    REMOTE ENDS = 100 EFS

    check:
    – Link with a mesureament PCM 2Mbit.
    – check bad connection
    – check equipment => Microwave?

    #56325
    sandeep
    Guest

    About crc bit ratio alarm

    #56326
    Jesus Alonso
    Guest

    How can i interprate the next
    parameters.

    < ZYMO:ET,607; LOADING PROGRAM VERSION 6.2-0 BSC3i QROCC4B 2015-12-21 16:04:37 PCM STATISTICS PERMANENT MEASUREMENT UNIT START TIME ET-607 2015-12-21 00:00 DISTURBANCES: DISTTYPE COUNTER LIMITS (MS) 10-50 50-200 200-1000 1000- NOINSGN 0 0 0 0 FALOST 94 1 1 1 AIS 32 4 1 7 REMOTE 554 526 138 19 FRAME ALIGNMENT SIGNAL ERRORS: COUNTER LIMITS (ERRORS/ 5 SEC) 1-39 40-79 80-159 160- 39 8 17 2 SLIPS: POSITIVE NEGATIVE 2 1 CRC PERFORMANCE MONITORING: TOTAL AVAIL UNAVAIL TIME TIME TIME LOCAL END 16:04:37 14:27:29 01:37:08 REMOTE END 16:04:37 15:55:00 00:09:37 (%) EFS ES SES DM LOCAL END 99.30 0.70 0.00 0.81 REMOTE END 83.65 16.35 1.21 16.44

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.