Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Conversion MegaBytes traffic to Erlang

  • This topic has 11 replies, 1 voice, and was last updated 2 years ago by Ahmed Elshafie Sir ELkhatim.
Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • #55581
    Aman
    Guest

    Hi, Can any body provide me the formula or methodology to convert site througput to Erlangs ?

    #55582
    nitin
    Guest

    hi
    can any one tell me how to convert megabytes traffic to erlang?

    #55583
    NiceGuY
    Guest

    I think there is no formula to convert Megabytes traffic 2 erlang since the Erlang is a unit of measurement of “intensity” of voice traffic, not a measure of saturation throughput of a connection.
    Unless there is an extented definition of “ERLANG”..
    Any additional clarification will be welcome..
    KinDreGarDs

    #55584
    Ayat
    Guest

    hello, i think in UMTS there

    Traffic (erl)*12.2 kbit/sec.*3600/8 = Kbyte

    12.2 AMR bit rate

    if video

    eraling *64 k bit/sec *3600/8 Kbytes

    #55585
    bill
    Guest

    how to convert payload in Megabytes to Erlang???

    #55586
    Debashis
    Guest

    How to convert GB to Erlang

    #55587
    Gyan
    Guest

    I think NIce Guy is very right , there is no direct calculation for converting Data Traffic to voice traffic or vise versa.

    all This calculation found in Internet is for Voice over IP or simple term when channels/TC are very fixed ie 1 or 2 ch/TC, may ch having capacity to deliver 64 Kbps, can calculate the erlang to Kbps.
    but when throughput is depend on, dynamically used Time slot and depend on request of Terminal

    #55588
    Debashis
    Guest

    Can anyone let us know….

    For 2G/3G voice we should take 12.2 Kbps & 3G Video 64Kbps while calculating for GB conversion.

    Or its has be doubled…say instead of 12.2 Kbps it it should 12.2*2=24.4 Kbps (UL& DL combined)

    #55589
    pix
    Guest

    hi,

    Downlink and uplink are using different “dimensions” (frequencies), so you can’t add them up.

    It’s like trying to add time to space.

    Jim, beam me up.

    #55590
    jeno
    Guest

    1. can anybody plz provide the difference in erlang value and MB value in data units.

    2. is it correct to use erlang unit in nsf and eupan network

    3. if “the Erlang is a unit of measurement of “intensity” of voice traffic”

    does it takes other data also ?

    #55591
    Haroldo Manoel Dornelas
    Guest

    Traffic (volume) = Traffic (Erlang) * 3600 * Bearer BR * AF

    Bearer BR = Channel Bit Rate
    AF = Activity Factor

    For voice services most vendors recommend to use 0.6
    For data services most vendors recommend to use 1

    #95230
    Ahmed Elshafie Sir ELkhatim
    Guest

    1 erl = 28.8 MB

    In RAN following Erlang B Table

    As 2% blocking

    1 erl = 4*16 Kbps*3600/8/1024 = 28.8 MB

Viewing 12 posts - 1 through 12 (of 12 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.