Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Ho Failure

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #55462
    r23
    Guest

    I have some cells that presente a big number of HO attempts (+ 2000 per week) but success is very low (< 10%) there is no Co BCCH, no same BCCH/BSIC. What could be the problem??

    #55463
    Pix
    Guest

    Are you sure there is no interference nor coverage issues? What about congestion in the target cell?
    What about the ho success rate in the other direction?
    Were you able to detect which adjacency was degraded exactly ?

    Perhaps all other neighbors are fine, just one of them is degraded. There is perhaps 0% success rate towards one main neighbor (0 success / 1500 requests) and 100% towards other neighbors (500/500)

    If all this has been done, then you can assume there is a soft/hardware problem 🙂 good luck…

    #55464
    r23
    Guest

    thank you Pix.

    I’ll check all what is in relation with interference.

    It’s a site situated in a high position (on a mountain). maybe coverage issues could made the problem.

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.