Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Reason of high ICM band in every site

  • This topic is empty.
Viewing 8 posts - 16 through 23 (of 23 total)
  • Author
    Posts
  • #55195
    Siva
    Guest

    Kindly note ICM Band is high for IBS site (Sector 5 & 6) . Please advise how to clear.

    #55196
    kitururu
    Guest

    High ICM band ( 2 and up) means there is interference on TCH and SD channels on Idle mode. do frequency scanning on the area to identify the cause of inter fences and check for hardware issues (jumper, connectors ) on antenna system installation

    #55197
    kumar A
    Guest

    how to resolve ICM value is high for IBS site? pls help me.

    #55198
    Wd3esa
    Guest

    Hello, I faced this issue in many sites, and solved by changing feeder loss values

    #55199
    Dayananda
    Guest

    Hi Devendra,,
    Normally we are facing ICM band high in Combine DAS (IBS),
    Reason:
    1. due to connector not done in proper manor.
    2.which you used accessories for DAS that accessories not meeting PIM value.
    3.Fq interface in from the BTS end
    4.if we have DAS connectivity in Inside the BTS room then you need to reduce the BTS room radiation.

    Diffrent B/W MIMO & SISO: in single word we can say,MIMO means multi input multi output ,,,SISO single input single output

    Regards,
    Daya

    #55200
    Kuna
    Guest

    ICM(idle mode Measurement) band troubleshooting..

    check for Co-BCCH, adjucent-bcch, Connectors, jumper and vswr test will help to identify what is the cause of Interferences..

    #55201
    Kalyan Borgohain
    Guest

    ICM found high in 1800 band.Please provide the check point to resolve

    #55202
    Shahbaz
    Guest

    How we can monitor high icm band, I know how to monitor rtwp.but icm band how I can monitor?

Viewing 8 posts - 16 through 23 (of 23 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.