Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

ANBSP analysis in Ericsson MSC

Viewing 4 posts - 16 through 19 (of 19 total)
  • Author
    Posts
  • #54588
    Vipan Sharma
    Guest

    I want to know to scp routing

    #54589
    wallis dudhnath
    Guest

    Hi Shweta et al,

    In the past I used to look at AXE10 and was very familiar with the numerous Man Machine Language (MML) commands that was used to configure resources for the switch.

    DT – Data Transcript – was used. Like a batch file with a list of MML commands.

    -B-Number Analysis is the almost the first analysis to be carried out in a
    call setup. ANBSI (Analysis of B-Number, Specification, Initiate) was the MML command that was used to B Number analysis.

    -The results of B-number Analysis will give the input data to the other
    analysis tables, for example, routing and charging analysis.

    -The first analysis to be done is the Pre-Analysis of B-numbers.
    This is used to reduce the size and complexity of the B-number table.

    For IN – Intelligent Networks – that is based on SSF/gsmSSF, SCF/gsmSCF, etc.. the MML command DBTRI was used to set up triggering. IN Flags, e.g. O-CSI(CAMEL), OICK/TICK, OIN/TIN, etc., is configured in the HLR / HSS.

    The IN flag is an enabler to help with routing the signalling to the gsmSCF. Call Control will be supported
    by the gsmSCF.

    VBR/ Wallis Dudhnath

    #54590
    malassane
    Guest

    anbsp should give you at least a routing case and with ANRSP you could get the route to use for the call

    #84063
    Prafull
    Guest

    Dear any one have Ericsson Doc with command output and description of each parameter please

Viewing 4 posts - 16 through 19 (of 19 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.