Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

PDP success rate

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #54131
    yan
    Guest

    can any body help me for explanation for PDP success rate and what is the problem for low rate.

    #54132
    pix
    Guest

    the PDP involves the GGSN, so a low success rate might mean that the PDP is unable to understand the APN defined in the MS, or unable to provide an IP adress, or there is some mistake in the QoS profile.

    Regards
    pix

    #54133
    yan
    Guest

    pix
    thank you very much for reply can you give me more inforamtion about APN

    #54134
    Da Architect
    Guest

    APN = Access Point 🙂

    #54135
    Eee
    Guest

    Access Point Name

    #54136
    Pix
    Guest

    APN is a character string written in the MS, either by default, by push-configuration or by the subscriber. This name (for instance “net”) would be then interpreted by the GGSN, in order to understand what is needed by the MS.
    HTTP ? FTP ? WAP ?
    Depending on the required service(s), a certain IP adress can be allocated to the MS.

    But ff the APN “string” is not in the GGSN, then I guess the GGSN is not able to allocate a PDP context.

    #54137
    GPRS
    Guest

    HI Pix,

    What are the causes of following message ?
    “unknown or missing ANP”

    Thx

    #54138
    pix
    Guest

    hi,

    Are you sure it’s not “APN” rather than “ANP” ? If missing APN, it means you didn’t input the APN parameters in your phone for the data service you are asking for (usually, one APN for MMS, one APN for web)

    Check your phone settings & operator guidelines to configure it.

Viewing 8 posts - 1 through 8 (of 8 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.