Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

RXQUAL

  • This topic has 3 replies, 1 voice, and was last updated 16 years ago by RH.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 29th August 2008 at 09:37 #53725
    MKT
    Guest

    Hi,

    RXQUAL refers to DEDICATED MS.

    BAD RXQUAL refers to HIGH BER.

    What causes BER?

    Hardware
    Interference.

    If Hardware is OK then

    the only cause left over is interference.

    What causes interference in DEDICATED MODE?

    POOR HOPPING PLANNING.

    So can we say to improve the RXQUAL

    One has to focus only on HOPPING SUBJECT.

    Regards

    Regards.

    29th August 2008 at 09:42 #53726
    MKT
    Guest

    Any third CAUSE which can results in BAD RXQUAL.

    29th August 2008 at 10:28 #53727
    MKT
    Guest

    Can we have the equation between No of intracell handovers and Hopping?

    That is ,

    More the no of intracell handovers = Poor hopping in the cell/network

    29th August 2008 at 11:21 #53728
    RH
    Guest

    We found in our network, HW related problem (like faulty trx, poor calibration of DRI, loose cable and connector) and interference both in BCCH and hopping ARFCNs are the main reasons for high BER.
    Ya I agree that the more intracell HO indicates poor frequency palnning in the network.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.