Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Rverse to old channel

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #52760
    Optim
    Guest

    Dear All

    what’s the meaning of this messager

    radio interface failure reversion to old channel

    regards

    #52761
    pix
    Guest

    handover failure with reversion of the mobile towards its previous serving cell, on the TS previously allocated to it.

    #52762
    Optim
    Guest

    Could you please give me more details about the reason of this problem , i suspect hardware problem

    #52763
    rahul
    Guest

    tell me how to airtel cell no. address

    #52764
    Optim
    Guest

    what do you mean ?

    #52765
    pix
    Guest

    yes, it’s probably hardware, or erhaps the taret TRX is using a frequency that is interfered. So the MS cannot access this particular TRX.

    Normally HO failure is also linked to the CSSR. In both case, the MS tries to access a TRX.
    If HO failure, then there should be also a low CSSR.

    Is it your case ?

    If not then you must suspect a problem linked to HO only (wrong parameters ?)

    #52766
    Rik
    Guest

    I´ve seen this problem in asignment fail rate causes, it decrease the CSSR and oftenly is a hardware problem with a TRX, i recomend you to check the RXlevel in UL or DL in each TRX, a bad TRX generally reports bad signal levels

Viewing 7 posts - 1 through 7 (of 7 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.