Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

rx_lev full and sub

  • This topic has 5 replies, 1 voice, and was last updated 16 years ago by akefa.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #50747
    rcdece
    Guest

    what are the cause why we encountered large difference between rx level full and rx level sub? for example rx_lev full is -95 and rx_lev sub is -55.

    #50748
    Pix
    Guest

    It occurs when there is no voice transmitted in the direction of the measurement and DTX is activated in this direction as well.
    For instance : DL RXLEV FULL = -95 and DL RXLEV SUB = -55, means that very little voice is transmitted in the downlink direction and DTX DL is enabled.
    FULL : measurement is done on all TCH, even if nothing is carried on it.
    SUB : measurement is done on SACCH frames (it always contains data)

    #50749
    rcdece
    Guest

    thanx pix for your reply.

    just a follow-up question, what possible action to do to solve this situation, is there any parameter we should change to to solve this problem. thanx

    #50750
    Pix
    Guest

    it is a normal situation. what do you want to solve ? adapt your work and your methods accordingly to your network settings.

    don’t try to change the network to suit your knowledge 🙂

    RULE : During drive tests using DL DTX, always look at the RXLEV-SUB.

    #50751
    m@u
    Guest

    If you want to change that behabiour you have to disable DTX on your cell, but that could lead to decrease in the performance of that cell.

    #50752
    akefa
    Guest

    in the tems make the rxlev full disapear 🙂

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.