- This topic has 23 replies, 1 voice, and was last updated 13 years, 10 months ago by Abdel.
29th November 2007 at 10:14 #49726pixGuest
and within a market area, there is no other solution than to put an antenna at 12m high ? (+6m pole ??)
you could put 3 or 4 microcells at 3m high, i’m sure there are possible candidates for this kind of installation. Antenna for microcells are not intrusive at all, they are as big as my hand 🙂
xavier29th November 2007 at 10:55 #49727AbdelGuest
For some security reasons we can not put the antenna on the ground where somebody can reach. So there is no land we can buy there since it is already occupied so the only option is to put on the second floor of the BTSs. I think the best solution is to install this 1800mhz antenna on the 6m monopole and then if the capacity is not enough then we have to split that microcell into two equal parts or reducing it to half of its current coverage.29th November 2007 at 15:15 #49728paraHOGuest
I remember some years back the area of Leicester Square in London near the Odeon Cinema where they premier major films, the area has lots of people and reporters using their mobiles during premiers. To overcome installing Microcells or small cell coverage (middle layer) they installed picocells all around the Square.1st December 2007 at 11:56 #49729AbdelGuest
It is exactly the same as film premier everybody wants to make calls simultaneuosly,during their bussiness hours and they are concentrated in a small area even the seaport is 300meters away.The businessmen bring their products from the seaport to this small congested area and thats where people come to buy it. You can not drive there, you have to walk.
Abdel1st December 2007 at 11:57 #49730AbdelGuest
do you have any recommendation about the file. I am waiting for your answer.
Abdel1st December 2007 at 14:49 #49731pixGuest
ok, i got the file, i’m going to answer by email 🙂
pix15th December 2007 at 16:13 #49732TNSGuest
Is this topic already closed…?
Would you share with us what did you decide to do?
TNS15th December 2007 at 22:29 #49733pixGuest
as far as i understood, they’re totally tied up : they’re gonna install a macrocell antenna on rooftop. they can’t change the decision…
i recommended maximum electrical downtilt, and 30dB attenuation to start with. And then gradual increase of the power in order to reach a nice “micro” coverage.
wait and see…
pix20th December 2007 at 18:30 #49734AbdelGuest
Yes it is on the rooftop and I tried some sites to change the antenna position but there are too many blocks the closest building is 10 meters away that is the street and the signal will be blocked anyway we will try our best do make the coverage as small as possible.