Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

non-typical cell configuration

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #49121
    evegnius_b
    Guest

    Hi, all.
    I need some consulting.
    We have problems with interference at GSM band.
    There was an idea to use 2 antennas at different heights for 1 cell. Higher antenna for coverage, other for capacity.
    No any additional features to control traffic – only handover parameters.
    Can you give some ideas of advantages and disadvantages of that configuration?
    Anyone realised that in a live network?
    Thanks

    #49122
    Pix
    Guest

    Hello,

    It is possible to have such configuration. The only impact you have is a loss of TX POWER. Indeed, you must use a power splitter to split the signals between antenna 1 and antenna 2. That leads to a 3dB loss !!

    It’s quite big, especially considering that one antenna should be for coverage only !

    Best solution : split your bts in two sectors.

    #49123
    aso
    Guest

    dear
    If you Use the same Band for two antenna it will make you problem for example is the height is not the same there will link imbalance and cause performance of the cell bad .
    But if you use two different band for expamle you can use 900 for coverage and 1800 for capacity

    #49124
    evgenius_b
    Guest

    Thanx for your answers my friends.

    To Pix:
    I forgot about power reducing. Thanks.
    You mean it`s better to use 2 different cells istead one, don`t you?
    (higher cell for coverage the last one for capacity)

    To aso:
    We already use GSM1800 everywhere for capacity.
    And traffic control algorithms seem very good.

    But problem with GSM900 is increase with building of new sites. It`s due the lack of available ARFCN.

    So the idea to add GSM900 microcell layer to reduce traffic of high cells and put as much traffic as possible to underlayer.

    #49125
    Pix
    Guest

    Yes, i meant this : use two cells.

    #49126
    Javed Shaikh
    Guest

    why we placed cell site in center in hexagonal cell & why we can use hexagonal cell site instead of circular cell site.

Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.