Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Alcatel A9100 BTS

  • This topic has 7 replies, 1 voice, and was last updated 5 years ago by Mer.
Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #48219
    Mer
    Guest

    Hi,

    I have a problem in an Alcatel BTS A9100 (indoor GSM 4+4+4), the problem is located in sector 3 with 4 TRX (X polarisation antenna:+45,-45),always there is one TRX down with this message(alarm 10 class 10 in BTS Terminal):
    TRE-VSWR:a fault has been detected by the VSWR supervision on the TRE output during initialization or operation states…
    the TRX is changed, the combiner is changed,the cable between TRX and combiner is also changed (VSWR of sector:1.1 1.1), this problem affect one,two or three TRX in the same time, now three TRX work and one is locked.

    thanks for all

    #48220
    aristotle
    Guest

    Hi mer,
    you may need to reset the BTS to refresh the SW. However, you have not mentioned if you performed sweep test with site master. Try to check this as well.

    #48221
    pix
    Guest

    normally, this is an ANC failure… have you tried swapping TRX with another one ? The faulty TRX is the same, or is it the new TRX becoming faulty ?
    I would exchange the ANC by another one again, from sector 1 or sector 2, since they are working.

    You could also try changing the SUM card… and eventually, change the whole BTS 🙂

    #48222
    Shahnawaz
    Guest

    Hi
    in fact we are also facing the same problem, TRE5 of SectorGSM C,after lock/unlock TRE got busy but after some time it went down again
    what we have done so far is:
    -changed the TRE
    -changed the CSO3 cable
    -changed the port of the ANC
    -changed the slot of TRE
    -done the offline comissioning of SUMA
    what next? please suggest if im missing some thing….

    #48223
    pix
    Guest

    bts cabinet inner cabling, possibly ? it looks like you have changed everything inside the BTS, so maybe the BTS cabinet is faulty.

    Have you tried to delete the cell, and recreate it from scratch ? Re-homing it to another TSU/TCU ?

    I don’t know… just suggesting.. you can also contact your regional support.

    #48224
    Mer
    Guest

    Hi

    in our side, we don’t find a solution or an explanation to this problem but we note some thing:
    after we make an offline commissioning, the problem return to the initial state (the famous TRE 9).

    #48225
    anuj
    Guest

    its been 10 year did anyone find the solution of it?

    #48226
    Mer
    Guest

    Hi anuj

    hhhh, yes more than 10 years 🙂

    the Whole region was swapped from ALU to Huawei

    BR.

Viewing 8 posts - 1 through 8 (of 8 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.