Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

TEMS decoding Neighbours

  • This topic has 2 replies, 1 voice, and was last updated 17 years ago by Tomar.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #46803
    Rajesh
    Guest

    Hi,

    I have a question on TEMS tool. In the “Serving + Neighbours ” window, i am observing BSIC and Frequency being decoded of the cells whose neighbours have not been defined in the network. I am observing this for the last one week only. How can this happen. We are using Tems 6.0, Nokia equipment.

    Our OSS has been recently been upgraded to 4.0 version. Any connection with this??

    Thanks and Regards

    #46804
    Pix
    Guest

    usually TEMS decode all signals, not only the neighbors… so it’s your previous situation that wasn’t “normal”. But I don’t know why it used to happen that way.

    #46805
    Tomar
    Guest

    Hi Rajesh, be carefully about TEMS measurement.
    Sometimes could happen that the decoding BCCH/BSIC is not OK.
    TEMS could measure BCCH=100 and BSIC=10, but in reality BSIC is defined BSIC=11.
    MS has some time to measure and to decode all SYS info.
    And if you have for example new site without definition in tems.cel, there will probably in the “Serving + Neighbors” window, cell with same BCCH+BSIC definition as you new site, but somewhere far a way.
    BR
    Tomar

Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.